Author/Editor		Navinšek, B; Panjan, P; Milošev, I
Title		PVD coatings as an environmentally clean alternative to electroplating and electroless processes
Type		članek
Source		Surf Coat Tech
Vol. and No.		Letnik 116-9
Publication year		1999
Volume		str. 476-87
Language		eng
Abstract		Today the development of clean technologies in all spheres of industrial manufacturing is an essential task, not only for material and metal finishing but also for plasma surface engineering. Among the most critical group of technologies which needs to be replaced by alternative technologies are processes used to produce functional galvanic and decorative coatings. The electroplating of finishes, such as hard chromium, cadmium and nickel in metal finishing is today recognized as a major source of environmental pollution in every country. Therefore wet bath technologies have started to lose favour compared with high performance dry coating methods such as physical vapour deposition (PVD), plasma-assisted chemical vapour deposition, chemical vapour deposition and thermal spraying. Among these techniques, the results obtained with PVD coatings in metal cutting and forming in the last 15 years show the most promising solution of the complicated situation in which galvanic coatings seemed to be technologically and economically irreplaceable. In this paper the general situation in this field is shown. Already today it is possible to replace efficiently some of the galvanic processes in specific cases (e.g. Cr, Ni, Cd, Zn, Au). It is important to point out that PVD is considered to be a technique which can provide not only metallic, but also alloyed and ceramic coatings with a virtually unlimited range of chemical composition and therefore controlled protective, mechanical and wear-resistant properties. Entering into competition with galvanic coatings the manufacturers of PVD coaters were confronted with new requirements: a huge quantity of substrates of the same size, to be chemically and plasma cleaned and then coated at the highest possible deposition rate. For industrial mass production one can therefore use only large PVD batch systems or in-line coaters. (Abstract truncated at 2000 characters.)
Descriptors		TECHNOLOGY ENVIRONMENTAL POLLUTANTS ELECTROPLATING NICKEL ALUMINUM CHROMIUM IRON CORROSION